How to get a millimetric sticker for router plunge depth

[koenbro]

I have recently purchased (and registered) an OF1400 and submitted a request on the Festool USA website asking for a millimetric sticker to put over the plunge depth marker. Today I got in the mail a catalog, but no ruler.  Anyone has any ideas how to get one? Thank you.

 

[RKA]

You're probably best off calling.  The contact form on the usa website is a dead end in my experience.  When I called I was bounced between customer service and service (so they could pull up the correct part no because the 1010 does use a stick on scale), but CS eventually got it shipped out.

 

[Svar]

Why settle with only mm if you can have dual scale:http://www.ebay.com/itm/45-90cm-Sel...easure-/401361334520?var=&hash=item5d72fff0f8:m:mrAVm-Cr9Kki5gaPQ76cTqA

 

[TinyShop]

[member=15585]Svar[/member] - The adhesive tape you linked to is 2.8 cm wide. How does this compare to the width of the installed scale?

[member=63837]koenbro[/member] - I've love to know how you make out in the end. If possible, will you keep us apprised? Thanks. 

 

[pettyconstruction]

Why settle with only mm if you can have dual scale:http://www.ebay.com/itm/45-90cm-Sel...easure-/401361334520?var=&hash=item5d72fff0f8:m:mrAVm-Cr9Kki5gaPQ76cTqA

Good idea,
Charlie

Sent from my iPad using Tapatalk Pro

 

[koenbro]

[member=63837]koenbro[/member] - I've love to know how you make out in the end. If possible, will you keep us apprised? Thanks.

I got the part number (#462622) thanks to the excellent, as always, Bob Marino and called Festool sales to order it. They were very helpful and sent out two at no charge via UPS. So I am pleased with the service.