Making some in frame units for a utility and have a drawer box to accommodate.
Usually I've made units which have overlay doors so I generally make the with of the drawer box approximately 18mm less then the cupboard width.
This is because I use the Blum drawer runners.
With the in frame is the generally accepted thing to do is pack out the runner so it's in line with the inside of the frame?
Or would you go further so the drawer front overlaps the box?
Usually I've made units which have overlay doors so I generally make the with of the drawer box approximately 18mm less then the cupboard width.
This is because I use the Blum drawer runners.
With the in frame is the generally accepted thing to do is pack out the runner so it's in line with the inside of the frame?
Or would you go further so the drawer front overlaps the box?
