BigCountry73
Member
- Joined
- Apr 30, 2014
- Messages
- 47
Hello all,
A quick...possibly dumb question -
When inserting a bit into the Festool Routers do you bootom out the bit or leave a gap? I know on my other routers I would leave a gap, but I wasn't sure about the Festool routers. I know with my table mounted router I place a small rubber grommet into the collet to keep the bit from bottoming out in the collet.
Thanks,
Keith
A quick...possibly dumb question -
When inserting a bit into the Festool Routers do you bootom out the bit or leave a gap? I know on my other routers I would leave a gap, but I wasn't sure about the Festool routers. I know with my table mounted router I place a small rubber grommet into the collet to keep the bit from bottoming out in the collet.
Thanks,
Keith