Is the CMS-OF MFT/3 attachment capable of height adjustment of an OF1400?

[RC]

I'm wondering can the height of an OF1400 attached to the CMS-OF base-plate be adjusted from above the table i.e. does it function as a router lift or not?

I'm eyeing the CMS-OF router table base module to convert my OF1400 hand held router into a table router when needed, but I haven't been able to find any articles or videos of it in action with a OF1400 (only of OF2200's atteched to it).
Nor did it look in any way straight forward to me how this could be done by looking at my router.

++ Ray

 

[bellchippy]

Ray yes the 1400 works the same as the 2200 as it does on the 1010, they just fit slightly differently to the rise and fall mechanism. It won't work with the older 2000.

 

[windmill man]

Ray

The 1400 and 1010 are adjustable from above when in the CMS of insert. Just like the 2200. Not tried it but hope it works better with them than the 2200

John

 

[Alan m]

[welcome] to the fog RC

Ray yes the 1400 works the same as the 2200 as it does on the 1010, they just fit slightly differently to the rise and fall mechanism. It won't work with the older 2000.

does the of2000 fit but not adjust from above

 

[jmbfestool]

Like mentioned  its the same as OF2200    and they can be adjusted from above AND below  but don't see any real benefits adjusting from below  unless you had attached some sort of jig to the setup and it was right above the hole where you adjust the height at least you can then adjust the height from below still with out need to remove your jig setup or something like that.

JMB