Kapex aftermarket T-track

[WPeters]

I saw a thread with a picture of someone who used these T tracks, to attach a clamp or crown stop.  They attached to the V-groove and have another v groove to allow the extensions to be attached as well.  Who makes them and where can i find them?  I searched for the thread but couldn't find it.  [sad]

 

[builderbob]

They're sold through multiblades.com

I use them with my UG extensions and they're awesome!

 

[WPeters]

Thanks!

 

[Bhend18]

I asked this question in another thread, but I'll ask it here as well since it talks about the same thing. The Festool crown stops don't fit in the t-tracks of the Multiblades brackets. Does anyone know of a different t-track that I could install that would accept the nut of the Festool crown stops?

 

[morts10n]

If you lookat the multiblade version with t-tracks, you'll see that a "continuous" crown stop (a 4"x24"piece of wood with 1/4-20 nuts and knobs )can be attached. I made one out of plywood and have not used the Festool crown stops since. It is impossible to cut crown shorter that 8" or so with the Festool ones.

Good luck

 

[Bhend18]

If you lookat the multiblade version with t-tracks, you'll see that a "continuous" crown stop (a 4"x24"piece of wood with 1/4-20 nuts and knobs )can be attached. I made one out of plywood and have not used the Festool crown stops since. It is impossible to cut crown shorter that 8" or so with the Festool ones.

Good luck

Yeah, I know a lot of people use a piece of wood but I already own the crown stops and was wanting to use them.

 

[festnoob]

They're sold through multiblades.com

I use them with my UG extensions and they're awesome!

I just bought them also and I have to agree 100%. Before anyone considers buying Festool's crown stops they should consider these.

 

[festnoob]

I asked this question in another thread, but I'll ask it here as well since it talks about the same thing. The Festool crown stops don't fit in the t-tracks of the Multiblades brackets. Does anyone know of a different t-track that I could install that would accept the nut of the Festool crown stops?

Just make your own. You could sell your crown stops; especially if you plan on ever using the UG extensions. The crown stops and extensions don't mix, unfortunately.

 

[Roadkilled]

Does anyone have a link to the bolts they're using to use this as a crown stop? Would these be right?

http://www.powertool-supplies.co.uk/festool-clamping-kit-sz-ks.html