Bugsysiegals
Member
- Joined
- Mar 19, 2016
- Messages
- 909
As I was leveling the Kapex extension wings I noticed there's a gap between the Kapex deck and the extension wings ... to be exact, I measured it with feeler gauges and it's 0.018" / 0.457mm on the Left and 0.025" / .635mm on the Right.
I figured I'd just level the extension wings so this gap is approximately consistent down the length of extension but wondered if I should put some tape in the groove to minimize this or perhaps it's even adjustable somehow?
I figured I'd just level the extension wings so this gap is approximately consistent down the length of extension but wondered if I should put some tape in the groove to minimize this or perhaps it's even adjustable somehow?
