Kapex hold down

[bkharman]

Hey everyone.  I was doing a lot of cuts on my Hitachi SCMS (CR12) and really like the saw but am allergic to the hold down.  It does work, but screwing and unscrewing constantly gets old.  I was wondering if someone could give the the pin diameter to see if it would work with my hold down holes.

Cheers.  Bryan.

 

[TylerC]

Sure. 21/32” is the small diameter. 23/32” is the large diameter.

Is that what you're looking for?

 

[JeromeM]

Hey everyone.  I was doing a lot of cuts on my Hitachi SCMS (CR12) and really like the saw but am allergic to the hold down.  It does work, but screwing and unscrewing constantly gets old.  I was wondering if someone could give the the pin diameter to see if it would work with my hold down holes.

Cheers.  Bryan.

You have the diameter above. I have modified one to sort of work with my Makita, it involved a lot of hand sanding with wet and dry.