LR32 markings

[Cochese]

This is my own fault, I admit, but I absentmindedly set my set of holes back from my leading edge at 32mm instead of 37mm. Not a huge deal in the scope of things, not worth going back and fixing - I can do that with how I make the edging and drawer fronts.

It would be nice, and fairly easy, to have a reminder to set it at 37mm for a front edge with a different color line on that measurement. Red, or even a Festool green.

Just a suggestion.

 

[Brice Burrell]

You could add marks with a sharpie as a reminder.

 

[TOOLTOWN]

Even though many brands (Blum and KV come to mind) use 37mm as the initial set back, not every brand is the same.  Putting a mark at 37 may be more confusing in the scheme of things.  I make it a habit to check the spec sheets every time I install hardware.  I've gone so far as to laminate a good copy to go with each of my most used bits of hardware.

Just my  [2cents]

Ken

 

[Cochese]

You could add marks with a sharpie as a reminder.

That's what I'll end up doing. Probably red pen on that line.

Even though many brands (Blum and KV come to mind) use 37mm as the initial set back, not every brand is the same.  Putting a mark at 37 may be more confusing in the scheme of things.  I make it a habit to check the spec sheets every time I install hardware.  I've gone so far as to laminate a good copy to go with each of my most used bits of hardware.

Just my  [2cents]

Ken

Interesting. All the ones I've used are 37mm, but come to think of it most are KV. I thought 37mm was universal for hinges, at the very least.