McFeely's and Festool bits

[fshanno]

I'm not sure what the fuss is about needing centrotec drivers...just put a 2" square drive bit it the centrotec holder air be done with it.  You can easily drive pocket screws with this setup, then switch to Philips
driver, or to a #1 square drive for trim screws without taking the driver out of the drill.  I do this daily installing cabinets and it saves me a ton of time.

My two cents.

Jon

This is not a solution for me.  For me square bits stick in the screw and render magnetic solutions useless.

 

[AlexThePalex]

If you want a dedicated Robertson square drive bit, just do this:

[attachimg=1]