MFS Hardware for a repetitive cut fence

[Ned]

That's what mine look like. 

Thanks again, Ned, you've been a big help.

Do you know if this part (and the v-nut that goes with it) is available separately?

You need to talk to Festool service/parts directly by phone.  I don't have their number handy.  Believe it or not, I don't have them on speed dial. 

There's a sheet included with the MFS kits that shows various parts and their numbers.  The long screws and right-angle nuts, set of 4, is part #493 094.  The joiner slot bushing that the screws go into, you'll have to ask.

Ned

 

[CharlesWilson]

That's what mine look like. 

Thanks again, Ned, you've been a big help.

Do you know if this part (and the v-nut that goes with it) is available separately?

I have asked about this one, and they weren't able to help me in the USA. I think it is possible to get the part on the other side of the pond, however. It seemed to have a part number on the Dutch website.

Charles

 

[Dave Ronyak]

The joiners are a spare part.  Part number and contact info are in MFS:  Notes on the MFS thread.

Ned

Thanks for clearing up my confusion, Ned.

Jerry Work's manual calls them special "V" nuts. You call them joiners and the Festool parts diagram calls them "along-binders".  I hope they're all one in the same.

I'm ordering part# 493-235 and hoping to get this

I recently ordered and obtained a set of 4 V-nuts complete with set screws under that part number.  $27 for the set.
I'm still looking for other pieces and parts for MFS.

Dave R.

 

[mhch]

This Festool www page is useful to obtain part numbers

          http://ekat.festool.de/EKAT/index.html