I made mine about 2mm less in width and depth but added several inches to the height(always felt the MFT was a bit low for me). Front has 2 sys ports and a third bank of narrower drawers. I found that one bank with one sys 3 and two sys 1's gave the same height as the other bank with two sys 2's and one sys 1. Both banks have a upper narrower drawer for hand tools and fasteners. Back has two drawers and two doors, holding sanders, nail guns, my compressor and one of my CT22's. Anyways it is still a work in progress as I have yet to assemble the doors. If you use 14" slides on the front you can get a CT in the back which was key for me as my plan is to mount my boom arm and get "Donkey" off the floor and out of the way. Planning to mount my dust deputy to the side as well, which will obviously make it bigger than the MFT footprint but still allow me to clamp on three sides.
Shoot me a PM if you want some dimensions and/or pics. I would definitely go frameless so you can maximize the storage, the MFT footprint is small enough already.
