mft with router table, incra ls, and precision plate

mlkm18 said:
The MFT is only my wishlist as an extension to the CMS, question is, can I connect the CMS and MFT?  Is there any available connector in the market, preferably from Festool, if not,  where?

The MFT/3 will not connect easily to a CMS GE; there are no Festool or 3rd Party connectors available, but you could make something yourself. Both tables are 900mm high, so the trick is to make use of the "V" groove on each table for connection and alignment.
http://festoolownersgroup.com/festool-tools-accessories/connect-cms-module-to-mft3/

For using CMS modules with the MFT/3 attached, the MFT/3-VL (or CMS VL depending on your country) is the way to go.
http://www.festoolcms.com/router-table/models/overview/
 
GarryMartin said:
mlkm18 said:
The MFT is only my wishlist as an extension to the CMS, question is, can I connect the CMS and MFT?  Is there any available connector in the market, preferably from Festool, if not,  where?

The MFT/3 will not connect easily to a CMS GE; there are no Festool or 3rd Party connectors available, but you could make something yourself. Both tables are 900mm high, so the trick is to make use of the "V" groove on each table for connection and alignment.
http://festoolownersgroup.com/festool-tools-accessories/connect-cms-module-to-mft3/

For using CMS modules with the MFT/3 attached, the MFT/3-VL (or CMS VL depending on your country) is the way to go.
http://www.festoolcms.com/router-table/models/overview/

Makes very good sense and should not be too hard making V-slot to match the  V groove even I am a newbie.

Many thanks Garry
 
Back
Top