tippmann205
Member
- Joined
- May 19, 2008
- Messages
- 1
any one having trouble keeping the gide rale and the miter square?
mft3
- Thread starter tippmann205
- Start date
- Joined
- Sep 22, 2007
- Messages
- 636
The MFT/3 is new and not too many have it yet.
Many of us have that problem with the older table and fence. Here is a thread on a manual I wrote discussing using bench dogs in the holes instead of the factory fence. You can download the manual and read it, only takes a few minutes. Those that have tried it, like it and many have switched over to using bench dogs and fences based on hole alignment.
Many of us have that problem with the older table and fence. Here is a thread on a manual I wrote discussing using bench dogs in the holes instead of the factory fence. You can download the manual and read it, only takes a few minutes. Those that have tried it, like it and many have switched over to using bench dogs and fences based on hole alignment.
