Moving sanders into one box.

[Brent Taylor]

I want to combine my smallerror sanders into one systainerror with a small amount of paper, one cord and the jigs I need to load paper and/or remove heads. I want to place a ROf 125, RTS 400, ETS 125 and a LS 130. I my also want to have room for my Mirka hand sander and it's hose. Will a 2 or a 3 be tall enough?  Thanks in advance.

 

[peter halle]

I moved a bunch of sanders into one systainer but is was the midi systainer.  I have the RO-150, the EtS 150, the DTS-400, and the RAS 115.  I also have limited paper, extra pads, etc.  It isn't pretty so I won't do images, but I suggest that you might want to look at a longer systainer versus taller.

Peter

 

[BPCFinishing]

I have the rts400 and the ro90 in a sys 2 with paper and extra heads for the 90,  I could probably squeeze one more sander in there if I kept it well organized.  Height of the 2 might be an issue for the 125?

 

[AlexThePalex]

I want to combine my smallerror sanders into one systainerror with a small amount of paper, one cord and the jigs I need to load paper and/or remove heads. I want to place a ROf 125, RTS 400, ETS 125 and a LS 130. I my also want to have room for my Mirka hand sander and it's hose. Will a 2 or a 3 be tall enough?  Thanks in advance.

I recently posted this picture in a thread where somebody asked almost the same thing. It's a RO150, ETS125 and DTS400 in a sys 2 and this shows how they fit. Lid won't close of course because of the 150. As the RO125 is smaller than the 150 you might be able to squeeze all your 4 Festool sanders in a sys 2, but there won't be much space for paper left. A sys 3 would give you some more space. I don't know how big your Mirka stuff is, so can't say anything about that.

[attachthumb=1]

 

[Brent Taylor]

Thanks for the inputs, I've got some time today to explore the possibility.  Thank you again.