juststartingout
Member
- Joined
- Mar 23, 2014
- Messages
- 57
Hi all,
I am at the point of putting finish on my hall table project after a lengthy learning experience with angled through tenons(this is only my second table). And now that it's all fitted and glued and sanded to a 500 grit, its' time for finish. So My question is, I've alraedy put one ocat of Arm-r-seal with a few drops of transtint dark walnut tint.
First learning. It didn't mix, and all the tint stayed on the bottom of my container.
The finish looks good the grain is starting to pop and look good, but, I would like a slightly darker tint. Given that I've already put arm-r-seal on am I too late?
Second Learning, Ask these questions before starting the finishing process.
Attached are a couple of pics of the project pre-finish. I'll upload a current status when I get back home to the project.
I am at the point of putting finish on my hall table project after a lengthy learning experience with angled through tenons(this is only my second table). And now that it's all fitted and glued and sanded to a 500 grit, its' time for finish. So My question is, I've alraedy put one ocat of Arm-r-seal with a few drops of transtint dark walnut tint.
First learning. It didn't mix, and all the tint stayed on the bottom of my container.
The finish looks good the grain is starting to pop and look good, but, I would like a slightly darker tint. Given that I've already put arm-r-seal on am I too late?
Second Learning, Ask these questions before starting the finishing process.
Attached are a couple of pics of the project pre-finish. I'll upload a current status when I get back home to the project.
