So I've been using a 12" speed square attached to the guide rail with an aluminium angle screwed to it for extra support for squaring up panels.
[attachthumb=1]
But I had no way of cutting multiple panels to the same length with out using some form of blocks of wood screwed to my cutting table.
So I came up with combining one parallel jig with the speed square attached to the guiderail. I had previously modified my parallel guides so I extend the stops to cut longer panels.
[attachthumb=2]
[attachthumb=3]
[attachthumb=4]
[attachthumb=5]
Now with this setup I can quickly set the stop to the desired length and cut multiple panels to all the same length. And they come out nice and square too.
[attachthumb=1]
But I had no way of cutting multiple panels to the same length with out using some form of blocks of wood screwed to my cutting table.
So I came up with combining one parallel jig with the speed square attached to the guiderail. I had previously modified my parallel guides so I extend the stops to cut longer panels.
[attachthumb=2]
[attachthumb=3]
[attachthumb=4]
[attachthumb=5]
Now with this setup I can quickly set the stop to the desired length and cut multiple panels to all the same length. And they come out nice and square too.
