parallel guide stops

[1toolshort]

I needed to use my parallel guide and track this morning.  Turns out one of the stops fell out.  I can't seem to find it any where.  Does anyone have a suggestion as to how to replace the stop (with the green cam lever, on the right and left guides).  They are hard to use without it...not impossible, but hard. I did not find anything online. Thanks.

 

[peter halle]

I believe you are looking for this which is in the EKAT.  Below are screen shots with part numbers and cost.  Hold onto your shorts.

Peter

 

[1toolshort]

$65++  Ouch...I think I'll look again on my shop floor!!  But many thanks.  That was it!!!

 

[RyanChildress]

I had the same issue. They want like 65 each plus shipping . I went rockler and bought 2 t track stops. They are totally useae and only cost 12 dollars for the pair if you don't count the 2000 dollars I spent on a domino and the two tendon systainer.

 

[guybo]

hi,the flag stops for the kapex work as well as the mft flag stop just clear knob bolt to fit $26 for mft and about 20 for other.It's a system [big grin]