Power feed for the CMS

[Rob-GB]

Mainly for the router table but it could also be useful for running out long strips of wood on the ts55/75 tables too.
Reason for the suggestion is that it can be tiresome running out long lengths of small mouldings and the consistent feed speed would negate burn marks, do away with jury rigged featherboards and add to the safety of the user too.

Rob.

 

[bkharman]

Mainly for the router table but it could also be useful for running out long strips of wood on the ts55/75 tables too.
Reason for the suggestion is that it can be tiresome running out long lengths of small mouldings and the consistent feed speed would negate burn marks, do away with jury rigged featherboards and add to the safety of the user too.

Rob.

There are a few folks who have made their own homemade ones. You can find quite a few videos on YT for ideas. I looked into it but ultimately ended up not doing it.

Cheers. Bryan.