Having a tough time getting consistent repetitive cuts. Ive been cutting 3/4 ply for a bookcase. Ripping 8' lengths I'm off by 1-2mm on some pieces. I've read the adjustment threads and watched all the youtubes. Am I missing something? Is it just the learning curve?
I have a t55, 2 1400 rails, parallel guides and a benchmark work table. I set the guide stops and check along the length of the pieces before I cut. Everything seems to be good except the consistency of the cuts. I think it would help if the guides were better supported, I've seen the tabs that some people have installed. I find it ridiculous that these things need modification for such an obvious condition. Frustrating.
Any suggestions welcomed.
I have a t55, 2 1400 rails, parallel guides and a benchmark work table. I set the guide stops and check along the length of the pieces before I cut. Everything seems to be good except the consistency of the cuts. I think it would help if the guides were better supported, I've seen the tabs that some people have installed. I find it ridiculous that these things need modification for such an obvious condition. Frustrating.
Any suggestions welcomed.