Question about GF Arm-r-seal

[bkharman]

Hey all,

Normally when I use arm-r-seal, I have the luxury or time to wait for adequate dry/cure times. I don’t have that on a pantry project at the moment. Bear with me here...

I have had three coats on the top of this countertop but completely forgot that I didn’t put a single on on the stained bottom side! (Insert funny jokes here)

I coated the bottom with a single coat this morning and it is dry to the touch. Question is, how long should I wait to install it. It is just the bottom and won’t be touched in the dadoes and rabbets but didn’t want to both anything up. My gut says wait until tomorrow morning, but I need to get rolling on the next steps and prefer to get it into place sooner. All thoughts are welcome!  Here is the underside right after I put the coat on.

Cheers. Bryan.

Sent from my iPhone using Tapatalk

 

[tjbnwi]

Carefully install it.

Leave the door open so the pantry can air out.

Tom

 

[bkharman]

Thanks Tom. It is open shelves and baskets, so it should be fine.

Hope all is well with you these days!

Cheers. Bryan.

Sent from my iPhone using Tapatalk

 

[tjbnwi]

Thanks Tom. It is open shelves and baskets, so it should be fine.

Hope all is well with you these days!

Cheers. Bryan.

Sent from my iPhone using Tapatalk

All is good. Making a few changes.....more to come.

Hope all is well with you too.

Tom

 

[bkharman]

So I got it installed. Fit like a glove!

Onto the trim and shelves. I will document the whole thing a bit later, but this is coming along nicely so far.

Cheers. Bryan.

Sent from my iPhone using Tapatalk