Right angle adapter for vaccum end of hose for CT26?

[sprior]

When my CT26 is sitting under my miter saw station I've got a 36mm non-antistatic hose from my Kapex that I'd like to plug into the CT26 with the hose sticking out forward from the vac as little as possible.  Does anyone know of a right angle adapter that plugs into a 2 1/4" (or is it 2 1/2"?), makes a relatively tight 90 degree turn and then becomes a female vac connector?  Or even better is there a 90 degree end I can replace on the hose itself?

I know the tool end of the hose that comes with the CT-MINI is 27mm, but is tapered - by any chance is the vacuum end of that hose 36mm?  If so I could get one of those ends.

 

[rst]

Oneida AXD600103 2.5" Right Angle SC Vacuum Hose Elbow Adapter

 

[MikeDVB]

I'd personally test how much a 90 degree affects things.  I know that in most piping situations a 90 degree bend significantly affects flow [I do a lot of aquarium stuff].

It may not be enough to cause you issues - but personally I'd probably try to avoid the 90 degree bend if I could.  Either way I'd probably do some testing.

 

[rst]

I have seven different vac setups utilizing Oneida's 90% bends and it has not affected any noticeable change in vacuum.  This is not to say that if some engineer tested my equipment with sophisticated equipment that he may find a loss, but in the real working environment...it's irrelevant.

 

[sprior]

In this case the usage is the 90 degree adapter will only be used when the Kapex is plugged into the CT26 directly via a shortened 36mm hose.  I think the loss of suction should be no big deal.

 

[pixelated]

I have a generic 2.5 in elbow that I bought for connecting my table saw to the CT26. Don't remember where I got it, it was either Woodcraft or Home Depot, probably Woodcraft though.