sheet good table, 4x8 or 2 smaller

[demographic]

Couple Of saw horses w 2x4s will work used them for a long time until I got my 2nd MFT or if you have a MFAt the extension table with some ply 4 ft long and some 20mm dowls that you can stick in the dog hole would work to I did it that way for a while to

Yeah, I use a couple of sawhorses with2 number 8 foot l9ng bits of 2x2 running lengthways and maybe 4 bits at about a metre long going crosways.
Thats basically my setup on site everyday and when needed my CTM extractor lives under the table out of the way.

 

[Tinker]

When I first set up my shop,I used a couple of Work Mates. With clamping table tops I had any number of possabilities.

Tinker

 

[Crazyraceguy]

hey guys trying to get my track saw sheet good (4x8 and 5x5) cutting off the floor. I have a 2.5 car garage and thinking this would go in the middle of the shop and used as outfeed table for table saw and glue up station.

would you go 4x8 for table saw, smaller? or would you do 2 separate 4x3.5' tables? That way you could like walk between them but still put a big sheet across it. I see them being on locking casters as well

I think either could work. The idea of being able to walk between the two smaller units sounds good, but could turn into a potential for a snag as an outfeed table? If you cut thin sheets they might droop into the gap. This could be mitigated by pushing them together, but you would have to remember to do it.
I have a 4' x8' cutting table near my assembly table. It has a section of T-track embedded into the middle of it as the measured stop for the track saw cutting station. A single sheet works best for this. It also leaves space for the router table insert on the other end.