Patrick Cox
Member
- Joined
- Apr 25, 2016
- Messages
- 173
Well, I am ready to screw together my first sysport box and when I measure corner to corner, I don’t get the same measurement. One direction is 940mm and the other is 950mm. What should I do? I felt like I may be a bit off because I had some problems getting my cut pieces to be exactly the same size. However in the end I thought they were close enough. I guess not - at least not to end up with a perfectly square box.
So now I am not sure what to do. Will a 10mm difference across this distance cause serious problems? When I measure various distances along the top and bottom they all seem pretty close. Meaning within a mm or so. Also my dry fit looks like I can screw it together without any problems. I just worry about the drawers.
Thanks or your input!
Picture below.
Pat
So now I am not sure what to do. Will a 10mm difference across this distance cause serious problems? When I measure various distances along the top and bottom they all seem pretty close. Meaning within a mm or so. Also my dry fit looks like I can screw it together without any problems. I just worry about the drawers.
Thanks or your input!
Picture below.
Pat
