TID18

[Birdhunter]

I went crazy yesterday and bought a TID18 even though I have a TI15  that works just fine. I used it a little bit and I really like it. The trigger is smooth and the power is awesome  Very compact.

I seem to be accumulating a set of Festoons that have been replaced with newer models.... TI15 and a C15. Both work, but never get used!

 

[lshah72414]

It's funny you posted this today, I was going to write about my experience with the TID 18 yesterday.
I own a C18, CXS(older model), a PDC 18/4 and I have owned the TID18 since they were introduced. In the past when building something, I would use the PDC and the TID in combination, one for drilling a hole, the other for screwing so I didn't have to stop and change. Yesterday, used the TID 18 solely, on a work bench I was building in my basement and was amazed that at the end of the day my wrist which is usely sore when using the other models felt completely normal. I set the TID to what I call "self adjust", where it decides the torque and let it do its thing. It drove everything without a problem and my wrist never was twisted or turned. Loved it!

 

[JINRO]

I have a quick question regarding TID18.  I am using Milwaukee Fuel18 Impact and Surge.  I tend to use Surge more for its less aggressiveness and smooth operation.  Most jobs can be handled with Surge alone, only needs Impact for some bolt to metal jobs.

- Is TID18 more similar to Fuel18 Impact or Fuel18 Surge?

- Does it lack any power/torque compare to either of Milwaukees?

 

[Birdhunter]

I am hoping that someone with the Tools you own and a TID 18 can help with the comparison. I own (until I find a buyer) a TI15 in addition the the new TID18, T18, C15(soon to be sold I hope), TSX and TSX. All great tools, but many redundant.

 

[sancho57]

you like it. I like mine though the switch is a bit touchy. Plus remember the 4 different modes

 

[Birdhunter]

My understanding is that the T setting is for drilling through sheet metal into wood. The next 3 lights , one by one, raise the limit on speed.

 

[sancho57]

yah the T is for drill though sheet metal using sheet metal screws. Ive kept mine on T most of tthe time.

 

[Birdhunter]

Why use the T setting if not drilling through sheet metal? What’s the advantage?

 

[sancho57]

To me, it works better, bc of the higher RPM.

Your milage may vary.

I think I might have moved to a slower RPM selection now.

 

[lshah72414]

The "T" selection is what I meant by "self adjust". The advantage to me is I leave it on that setting and I never have to adjust, the tool takes care of it for me. I don't overdrive or anything it just does it without me having to adjust the settings.