track saw clamps that don't stick out the bottom

Wonder if this would be a good solution for one side. Square up and act as a stop then use the gun clamp hanging off the end on the other side. Not sure how tight the tso gets though or how far down it hangs
d50aa44a617ff29b8792303b4ecf00e8.jpg
 
ben_r_ said:
treesner said:
ben_r_ said:
LINK yea that is something to consider, perhaps with something like on the other end: LINK
Click to expand...

oh interesting, wonder if it gets nice and tight like the festool ones i bought. i was thinking if i had the low profile on one side i could just hang the gun trigger thing off the end of the foam for clearance but might be worth trying that little guy too
Click to expand...
So was I, so I ordered the festool "gun" one. Might try the Rockler one too. If it goes on sale for cheaper.
Click to expand...
It's on sale been working good. It doesn't move around as easily as the festool one clamps into the foam a little bit but I just leave it set to a spot where the saw overhangs then the other side with the gun I have hanging off the edge of the foam and adjust that as needed. Haven't tried the rockler quick connect one

95251617200698e619aad87dc13fc86b.jpg


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.

Similar threads

R
Track saw track - Makita vs Festool
Replies
4
Views
425
ReneS
R
J
Warning: Woodpeckers Semble Clamps can Ruin Woodwork
Replies
5
Views
1K
leakyroof
leakyroof
S
Since when did track saw rail clamps become the defacto MFT clamp?
2 3
Replies
45
Views
29K
squall_line
S
J
T-slot router bit for t-track clamps
Replies
5
Views
519
John T.
J
brendanfalkowski
CSC SYS 50 with Woodpeckers Auxiliary Rip Fence (or just WP Super Track)
Replies
15
Views
22K
brendanfalkowski
brendanfalkowski
Back
Top