TS 55 EBQ

[ggoode23]

Hi Guys

I am having issues setting up my TS 55 EBQ to cut 45 degrees... its constantly cutting off by 2 degrees - making a perfect 90 mitre impossible - how do you guys do it?

Thanks

Graeme

 

[Holmz]

Howzit cut for angle at zero? I think there is an adjustment for it. I read about it often.

(Basically I wanted to use the only SA word in my lexicon. Howzit)

 

[tjbnwi]

Page 12;

http://www.waterfront-woods.com/festool/TS_55_EQ_US.pdf

Tom

 

[ggoode23]

Thanks very much for the resource -  [big grin]

 

[ggoode23]

Howzit cut for angle at zero? I think there is an adjustment for it. I read about it often.

(Basically I wanted to use the only SA word in my lexicon. Howzit)

Hahahaha thanks Holmz - one of my best mates is from Perth - I have taught him some foul SA words to use when he goes back home.

 

[Holmz]

[member=58434]ggoode23[/member] - There are heaps of x-SA in Perth. I saw my niece's room mates mom today... She was from Zimbabwe and owns a welding shop. Ran into a friend in the shoppes yesterday who was back near Kruger last month where he was from.
I have enough foul language, without requiring more.

 

[ggoode23]

hahaha damn Saffas. So i re calibrated the TS55 and have to run it off the track as it wont cut deep enough at 45 degress. No matter what i do ( i tried the method in the manual but I aint having any joy). I made a perfect 45 on my table saw, same thickness material and used this as a reference... still cutting the material off. FFS i hate this kind of thing. Retard level 9.