Ug wings - only need one

[HowardH]

Can one order only the right side of the Ug wing set?  I want to use it as a long material support off my MFT/3.  I saw a video of Eric (erock) using one for that purpose but I imagine he just attached the right side unit off the set he has for a Kapex. I don't need another MFT/3 as a cutoff support table but if Festool won't break down a set, I may have to do that. 

 

[RKA]

Yes.
https://www.festoolusa.com/accessory/497352---ka-ug-r

 

[HowardH]

that's perfect... not cheap... but perfect.  I presume it will drop right into the profile and be the same height as the table top.

 

[copcarcollector]

I presume it will drop right into the profile and be the same height as the table top.

The main part of the UG extension will be at the MFT/3 table top height, but the 'fence' part of the extension sits up higher. Yes it will attach easily to the MFT/3 without any additional parts.

The UG extensions will NOT work on the shorter MFT Kapex table

[attachimg=1]

[attachimg=2]

[attachimg=3]

[attachimg=4]

 

[Bob D.]

I was wondering the same thing after seeing Eric's video and in searching
I came across this.
http://www.multiblades.com/mft3.html

Didn't buy one but bookmarked it because it looked interesting and I've
been meaning to ask if anyone here has used one with their MFT.

 

[HowardH]

I'm never ceased to be amazed about how someone can take an idea and make it their own.  A set of 2 brackets and folding supports is just a bit over $100.  The Festool version is $385.  You would still have to buy an Incra channel to be used at a fence but that's pretty minimal. I'm going to have to give that some thought...