Using an INCRA fence on a Festool CMS saw table.

[Charles Sharpe]

First of all Happy Christmas to you all. This is my first thread on this site. I am looking to improve the fence on my CMS and have been looking at the CS70 CA. I have read that its got its problems and I have also been reading about using AnINCRA super fence on the CMS if thats the case how do they fit onto the CMS table.

 

[nclemmons]

Welcome to the FOG Charles.  There have been a lot of discussions about the CMS fence and it's adjustability.  You could try searching CMS and Incra and see what you find.

Alternatively, This thread might give you some ideas:

http://festoolownersgroup.com/festool-jigs-tool-enhancements/cms-micro-adjust-and-other-suggestions-and-question(s)/msg334136/#msg334136

neil

 

[Benjamin]

Attach it to a crown stop

The crown stop will attach to the V groove of the cms

That's how I did it

http://festoolownersgroup.com/festool-jigs-tool-enhancements/another-cms-micro-adjust-(-using-crown-stops)

Or if you buy the cms that attaches to the mft table it's easy to attach it to the mft