VAC SYS Pads

[cpw]

I have the SE1 and SE2, which came with the oblong and the circular clamping pad.  I also bought a VT SORT, which has a second oblong pad, narrow pad, and 200x60 pad.  I would like to get a second of the narrow pad and 200x60 pad for longer workpieces where 1 unit isn't providing quite enough clamping power.  I've thought about getting the VT SORT, but then I'm going to have 3 oblong pads [and only two heads to connect them to], and would really prefer to have 2 full sets instead of 1 circle and 3 oblong.

Does anyone know if the insert can be purchased separately, or if there are dealers that can substitute one pad for another?

 

[Kanuka]

Did you actually look? Any dealer can get them.
https://www.festoolproducts.com/accessories/vac-sys-vacuum-clamp.html

 

[cpw]

If you get the VT sort:https://www.festoolproducts.com/acc...stool-495294-vac-sys-vacuum-pad-set.html?SID=

You end up with 200x60mm, 277x32mm, and 275x100mm in a Systainer 3.  I already have two 275x100mm, because the SE2 head already came with one of them.

So ideally would end up with:
580067 Vac-Sys Round Vacuum Pad, 215mm
580064 Vac-Sys Vacuum Pad, 200x60mm
580065 Vac-Sys Vacuum Pad, 277x32mm
In a Systainer 3, with the nice insert to keep them neatly organized.  I looked on EKAT, but could not find the VT SORT insert.  Preferably without paying for the third oblong pad that I wouldn't be able to use, in addition to the circular pad that I would.

 

[Cheese]

Just call Festool and tell them you wish to purchase the Systainer insert. I recently purchased the Systainer insert for RAS consumables.