Jeff Zanin
Member
- Joined
- Jan 2, 2009
- Messages
- 328
I got the VAC-SYS a few months ago and have used it for a number of projects, it is great for sanding and using the Domino. Shortly after I got it I made the plywood plate to mount the head to the edge of the MFT and the holder that fits around the MFT leg for the foot petal, but only recently found a good place for the vacuum pump.
I had previously made a shelf for the right end of the MFT to hold the TS-75, this was a big improvement over putting it on the floor, the MFT or the dust extractor. So for the vacuum pump I doubled down on that idea and made another one with a second shelf, it holds the vacuum pump up off the floor where it is handy to reach the front panel. A hole in the back of the lower section provides passage for the vacuum power cord.
Jeff
[attachimg=1]
[attachimg=2]
I had previously made a shelf for the right end of the MFT to hold the TS-75, this was a big improvement over putting it on the floor, the MFT or the dust extractor. So for the vacuum pump I doubled down on that idea and made another one with a second shelf, it holds the vacuum pump up off the floor where it is handy to reach the front panel. A hole in the back of the lower section provides passage for the vacuum power cord.
Jeff
[attachimg=1]
[attachimg=2]
