What is this clip for?

[RNEMTP]

This clip came with my cs-vl OF router table. I’m assuming it clips to the smaller of the 2 hoses but idk where the other side clips.

 

[RKA]

It looks like it fits into the top of the aluminum extrusion around the outside of the VL.  See the V on the right side of your picture...that probably fits into the V notch on the top of the extrusion. 

 

[RNEMTP]

I thought that too but the part that isn’t V shaped doesn’t fit.

 

[xedos]

Looks like it's for holding / routing the power cable.

 

[AlexThePalex]

[attachimg=1]

 

[RNEMTP]

Thank you! Now I see. It won't work on my setup because I have the VL not the GE. The profiles on the VL are the same as the MFT/3. If it had just the v channel without the t-track below it, it would work. I don't really need it anyways because I am only using the OF module.

 

[Gregor]

Thank you! Now I see. It won't work on my setup because I have the VL not the GE. The profiles on the VL are the same as the MFT/3. If it had just the v channel without the t-track below it, it would work. I don't really need it anyways because I am only using the OF module.

It works with the MFT/3 profile without problems, it only interacts with the V-grove.
It's a bith tricky to attach though (on both profiles), especially when new.

 

[Coen]

And when older... it gets a bit more brittle and then snaps when you try to attach it when it's cold  [blink]

Replacement part nr is 450158