Your goto guide rails

[mkasdin]

About the connectors, I have seen Festool Youtube live about the track saw and Sedge gave a really good trick when connecting 2 rails. Leave a small gap between the rails and use the track saw to line up the rails before tightening the connector screws. I tried it and it works well.

it works ok, but the tracks have a tolerance since they are not machined and just extruded? The Betterley connector works better from the people I’ve spoken width, but you still have to contend with minor differences in tracks. Not the case with mafell-Bosch tracks. I don’t like spending my time aligning tracks and I have no way of storing long tracks. I would still need a 1900 and 3000 track if I wanted to get precise cuts, assuming the tracks didn’t get damaged in transit, storage or on the job-site?