4 inch router bits

[Rocky]

Is there a hand held fixed or plunge router can accept 4 inch bits?

 

[Rocky]

My same thoughts.  I would that size would be for a shaper.  But I saw it referenced in the current Poll and thought I'd ask.

thanks,

Mike

 

[tbellemare]

I think a 2200 can handle about 3-3/4" bits. What bit are you considering?

Tom

 

[Rocky]

This was quoted in the poll: I'm voting for the Carvex since I actually want that one (even though I know it's coming anyway...)

I agree it makes sense to ask for added CMS modules to actually make it into a system, but for my part, it wouldn't be the TS module... I personally don't care much for table saws, would be more likely to go for the jigsaw module.

I would go for the OF 2200 module if I knew it could actually handle the nearly-4-inch bits that the smaller ones apparently cannot?

 

[dsweetser]

I have used a 3 5/8" panel bit many times.

 

[peter halle]

I have removed my earlier post.  The catalog doesn't specify the maximum size bit.  I pulled a dimension out of an incorrect column.  OOPS.

Peter