Compelling reasons to buy MFK700 Edge Router in addition to OF1010 Router?

I have three routers. The OF1400 serves as my general purpose router. I added the table widener and it was a fantastic addition. Next I have a 3.25 HP Bora motor only router in a table that is used for stiles/rails, adding profiles, etc. I have been quiet happy with the Bora router and the cast iron Jet table/lift but would look at shapers if buying new today. Last is the MFK700. Most of the time I leave it setup to trim edge banding and for this it is flat out a terrific solution.

If you don’t have edge banding needs, I would suspect the OF1010 will be just great for you.
 
Back
Top