This question sounds like it's referring to bevel cuts and whether anyone has arrived at a good solution to extend the range of the track saw's 45 degree bevel limitation.
It so happened today that I had to bevel a board 118º from horizontal. The piece is 20-1/2" wide, the saw was set at 28º. From the time I got everything out and set up, it took 16-1/2 minutes start to finish.
[member=15585]Svar[/member], thanks for the pad out suggestion, it made stop and think, padded up instead of out.
Set up. Mistake here was just grabbing a pieces of car siding for the support. View attachment 1