Get the Router Bit Systainer?

[FEStastic]

Hi,

[attachimg=#]

I used the inserts that came with my set when they were used up I took a file to a 13mm drill bit  when spinning in the drill press  (be carefull  [eek] )
took off just enough to get a snug fit. Used a Systainer 1 .The base was 25mm MDF.  25mm giving more support then 18mm and inserts sit flush. 
Longer bits are kept in the main Sys 4 with the router, inside a mini sys
I prefer this as it keeps everything tidy in the main box

 

[GPowers]

Hi,

I used the inserts that came with my set when they were used up I took a file to a 13mm drill bit  when spinning in the drill press  (be carefull  [eek] )
took off just enough to get a snug fit. Used a Systainer 1 .The base was 25mm MDF.  25mm giving more support then 18mm and inserts sit flush. 
Longer bits are kept in the main Sys 4 with the router, inside a mini sys
I prefer this as it keeps everything tidy in the main box

Thats is a LOT of router bits, nice setup.

 

[FEStastic]

these are just the ones I talk to site. Had a good run of work  [big grin], upgraded to 1/2 inch so all the old miss matches ones stay in the workshop

 

[GPowers]

these are just the ones I talk to site. Had a good run of work  [big grin], upgraded to 1/2 inch so all the old miss matches ones stay in the workshop

lucky dog, must be nice!