Hi all, picked up a new 1900 guide rail today, and on getting it home and checking it over, noticed what appears to be bend at one corner.. It's noticeably rounded over, and also tapers slightly with a clear lip to the extrusion on the outer cut edge of the underside - to me it looks like a manufacturer error rather than damage.
I'm looking for some advice from those more clued in than me as this seems to be the last 1900 rail available until late May (according to Festool Australia). With that in mind, I'm thinking I could make the end with the bend the starting side for cuts, I doubt I'd cut that close to the edge with the required overhang anyway. But I'm unsure how it impacts the rest of the rail, if at all?
I'm looking for some advice from those more clued in than me as this seems to be the last 1900 rail available until late May (according to Festool Australia). With that in mind, I'm thinking I could make the end with the bend the starting side for cuts, I doubt I'd cut that close to the edge with the required overhang anyway. But I'm unsure how it impacts the rest of the rail, if at all?


