Chris Hughes
Member
- Joined
- Mar 15, 2008
- Messages
- 572
What the? I was flipping through my Hilti catalogue last week and came across a guide rail for their saws. Again, what the? Well today I had to pick up some fasteners so there I was in a Hilti store. So just in passing I asked about their rail and it just so happened that they had mis-ordered something and ended up with a rail. I believe they call it a wng 1400. My ts 75 mounts directly to it and all other clearances line up. Their rail has a large notch at the start of the rail just where you would set your base to start the plunge. The rail has the same three pads on the bottom as chip guard and no slip. Hilti deleted the outside clamping track and added an integrated cut out handle. Hilti has lent me the rail to kick around so I'll give the full shake down if anybody is interested. C Hughes