Hammer A3 41 digital hand wheel install and calibration

Can anyone help with the install and calibration of the digital hand wheel for the hammer A3 41

  • N4400

    Votes: 0 0.0%
  • K3 winner

    Votes: 0 0.0%
  • A3 41

    Votes: 2 100.0%

  • Total voters
    2
Jphelps327 said:
Digital hand wheel setup and calibration. No instructions came with my A3 41. Help

Simple.. well was for mine, thickness a piece of wood, measure it with a micrometer/calipers, take the hand wheel off and turn it to get the same reading (the digital dial is weighted by gravity so just get a piece of pipe of dowel and spin the wheel till you get the same reading as the callipers, then put the wheel back on the thicknesser
 
I noticed the dial would not move when it was rotated. There is a nut on the back of the dial and apparently too tight  I loosened it some with pliers and it works like a champ. You would think after paying $6000 for a machine there would be some instructions for the setup and calibration.  I love my hammer machines though.
 
Back
Top