This machine is a single-phase 230V motor. No surprise there, just wanted to be clear.
The rear safety 'switch' is pulled up with shield in place and the big red button on the left side of the machine has been tried both in and out. (I am still not sure what this button is actually for. May be a kill button.)
[attachimg=1]
My connectors are all L6-30A with a 10GA extension cable. Breakers are 30A.
[attachimg=2]
I went so far as to break open the machine plug to make sure that both hot leads are getting 120V and they both are. I also double-checked that I connected the ground correctly in all connectors.
Recap: I have tried starting the machine with the red button both in and out and rear safety lever up. The motor is definitely getting the correct voltage, but it won't budge.
Any suggestions will be greatly appreciated.
Thanks!
The rear safety 'switch' is pulled up with shield in place and the big red button on the left side of the machine has been tried both in and out. (I am still not sure what this button is actually for. May be a kill button.)
[attachimg=1]
My connectors are all L6-30A with a 10GA extension cable. Breakers are 30A.
[attachimg=2]
I went so far as to break open the machine plug to make sure that both hot leads are getting 120V and they both are. I also double-checked that I connected the ground correctly in all connectors.
Recap: I have tried starting the machine with the red button both in and out and rear safety lever up. The motor is definitely getting the correct voltage, but it won't budge.
Any suggestions will be greatly appreciated.
Thanks!