As some of you know, I have been configuring my MFT as my outfeed table for my TS. I got a 1400/2 rail and have the MFT setup with the stops on the short sides. Combined with the TS it's a nice big surface. Well, that being said, I got everything calibrated tonight and went about hacking up some melamine for a shop cabinet. I just started with 16" wide x 96" shelving as I wanted a cross cutting nightmare for my shop. I am not setup to deal with something that long at all. So, it was a job for the MFT and the TS 55. Well, using that thing is like cheating. After I learned to trust my calibration of the guide rail and fence, I rattled off about 16 cuts and at the end wished I had 16 more to make. I debated taking some video of it, but I spared you all the rather mundane vision of my excitement on a tool system working EXACTLY the way it is supposed to.
I just wanted to rave a bit!
Cheers!
I just wanted to rave a bit!
Cheers!