paulhtremblay
Member
- Joined
- Jun 4, 2014
- Messages
- 148
I can't be the only one who cut through (or nearly through) my MFT3. I had just changed the blade and did not set the blade back to the 21 mm setting. In the future, I need to remember to always re-set the depth after changing the blade. It might also help to store the saw at 0 mm setting.
I usually check before each cut (or at the start of cutting), but apparently didn't yesterday.
I was going to order on through Bob Merino's Festools, but I see they are on back order. Anyone have another source?
I usually check before each cut (or at the start of cutting), but apparently didn't yesterday.
I was going to order on through Bob Merino's Festools, but I see they are on back order. Anyone have another source?