In fact, because it was recently purchased they are sending me a new one with a shipping label to send my old one back so I am not without one. Very impressed. It is a 300mm 1281 aluminum square. I used a skinny sharpie to test. Then a .5mm mechanical pencil to retest. It was about 2mm off on the outside but dead on the inside of the square.
How to test Woodpecker square tolerance?
- Thread starter ferntree
- Start date
Cheese
Member
- Joined
- Jan 16, 2015
- Messages
- 12,528
ferntree said:
This is the same thing they did for me when I had a squareness issue with the Model 6SS carpenters square when it was first introduced in 2014...absolutely great customer service. [thumbs up] That's one of the reasons I keep coming back.
