Hello,
When reading through the forums, i thought maybe my Version of a Multi Function Workbench might be of interest to some.
Just some pictures to start with:
[attachimg=1]
[attachimg=2]
[attachimg=3]
If i would build one again, i wouldn't put those bevels on the Aluminium rails any more.
They were intended to provide access to all slots on all 4 sides of the table, but they're a mess to cut.
Same goal can be reached by having the long front rail about 12mm shorter on both ends (24mm total).
The profiles are ITEM, Size 8 (mainly 80/40). I just found out they're also available in NA http://www.item24us.com/
The normal Festool clamps fit into the slots.
The FS-Rapid doesn't fit out of the box, but i think you could do it by exchanging the nut.
Max
When reading through the forums, i thought maybe my Version of a Multi Function Workbench might be of interest to some.
Just some pictures to start with:
[attachimg=1]
[attachimg=2]
[attachimg=3]
If i would build one again, i wouldn't put those bevels on the Aluminium rails any more.
They were intended to provide access to all slots on all 4 sides of the table, but they're a mess to cut.
Same goal can be reached by having the long front rail about 12mm shorter on both ends (24mm total).
The profiles are ITEM, Size 8 (mainly 80/40). I just found out they're also available in NA http://www.item24us.com/
The normal Festool clamps fit into the slots.
The FS-Rapid doesn't fit out of the box, but i think you could do it by exchanging the nut.
Max