Just got the MFT3...What cool things is it useful for ???

[Kev]

Hey Peter,

I just got back from a Festool end user class.

I asked Steve to hunt down a watch heheheheh.

Great stuff Sancho - I hope you get one. Remember to do the calibration check when it arrives and also make sure it is set up for your particular Domino. Mine needed adjustment at the beginning but now all of my Domino work is 100% accurate - time after time...

Peter

Peter, I hope that's chocolate on your watch !

 

[Stone Message]

Peter, I hope that's chocolate on your watch !

I think it might be blood from the fight to get the watch! Its about time I cleaned it off then I can tick off another task.

 

[sancho57]

Those watches are very hard to get. Steve said they were some special gift given with a purchase . T

hey dont have anymore of them.

But my hunt will continue.

It may take a long time.

Looking around the clock for one.

I can see where it would be helpful with a domino.

I can use it over and over, time after time..

I will not be denied :>D

 

[Stone Message]

Hi Sancho

If all else fails, there is always ebay!

Peter

 

[sancho57]

Ya Ive never really been to ebay or bought anything off it

 

[sancho57]

took a couple of old sheets of ply screw cleets on both ends and set it in the crossmembers of both MFTs. This way even though my WC is full of clamps etc I can set all the sustainers I need for the job at hand on the shelf and not have to walk over to the sys port to get the tool.

I try to save me time anyway possible.

If I can save a few steps Im happy

 

[honeydoman]

several ideas also  is it works great for having your lunch on while at a job......
thanksgiving when everybody is over and you need an extra place for the in-laws to sit......
just to add a few.... [laughing]

 

[Ken Nagrod]

Good idea, Kreg!  You can clamp the turkey down and use the TS 75 to cross cut or rip slices.  Use the TS 55 for the cranberry sauce.

 

[sancho57]

and use the parallel guides rail and ts to carve the bird, faster easier smarter  [eek]

 

[Stone Message]

and use the parallel guides rail and ts to carve the bird, faster easier smarter  [eek]

Come on Sancho...you need the CARVEX for that!

I have just taken mine out of the box - it arrived yesterday.

Peter

 

[sancho57]

Your right Peter,
make sure you use the CT to ensure you dont get pieces of bird all over the MFT