MFT/3 question

[SMJoinery]

Hi All

Quick question. I have the basic versions but not the hardware (guide rail hinge etc).
Can the hardware be used on the short length of the table?
I understand the guide rail might have to be a longer one but only ever see it used with the hardware on the long edge.
Thanks
Scott

 

[richy3333]

Hi Scott.
Yes it can be used on the other side. From memory the rail that comes with the MFT package isn't long enough but a 1400mm one would be. With the way it works I think you could fit any size of rail you wanted, it might just not slot into the far locating pin unless it is too long/ or long enough. So a 3m long rail could be used, but you would have a long length hanging off the end that would be superfluous. Hope I've explained my self well enough?

 

[SMJoinery]

Hi Scott.
Yes it can be used on the other side. From memory the rail that comes with the MFT package isn't long enough but a 1400mm one would be. With the way it works I think you could fit any size of rail you wanted, it might just not slot into the far locating pin unless it is too long/ or long enough. So a 3m long rail could be used, but you would have a long length hanging off the end that would be superfluous. Hope I've explained my self well enough?

Thank you and yes you nailed the explanation.
Hope Santa was good to you.
Cheers
Scott