MFT top from Full sheet from Phenolic film face plywood

[grayedout]

HI All , I am working on an idea for a MFT table using a full sheet of Ply.  not sure if this has been done could find any info ..  I am right in thinking the MFT has 20mm holes 96mm apart and 60mm in from edge ?

Will upload picture and Youtube of the build when I get this going

Best
Andy

 

[Redart]

Hi Andy, cant't wait to see the pictures of the build,
the 96mm spacing isn't necessary as long as the 20mm holes are square , but most important in an assemby table top is the perfect flatness. maybe a torsion box..