MFT Zero-Clearance Fence & Fenced Sled

Peter_C said:
The dogs need to be threaded so they can be screwed down from below. Otherwise as a clamp is tightened it will damage the 20mm hole in the MDF.

I have not had an issue with the expandable portion of my clamp dogs damaging the MFT's holes. And this was an issue I had been concerned about from the get go.

 
Corwin said:
Peter_C said:
The dogs need to be threaded so they can be screwed down from below. Otherwise as a clamp is tightened it will damage the 20mm hole in the MDF.

I have not had an issue with the expandable portion of my clamp dogs damaging the MFT's holes. And this was an issue I had been concerned about from the get go.
Could be because I am using the 6" Automaxx clamps that put more offset strain on the holes. I had noticed it torquing the holes and thereafter always screw it down. The clamps absolutely rock! Being able to go from a 2x4" to 1/4" sheet without any adjustments is just right.
25k5912s03.jpg
 
Back
Top