Mid panel domino joinery in 0.5" plywood

[Stoli]

Here is a method to use a domino to perform mid panel joinery in 0.5" plywood. The standard technique won't work well because of the 10mm spacing between the base and center of the bit in the 500. My method is to increase the offsets by 4mm using 4mm dominos themselves as spacers. This is also an entry into the video contest.

 

[Nippychippy]

Really nice method I'll have to remember that thanks for sharing

 

[RDMuller]

Excellent!  Thanks for sharing.  Very good straight to the point video also.

 

[Jimmy FineCut]

Great tip, thanks.

 

[Srbrownjr175]

Domiplate.....?

 

[Stoli]

Domiplate.....?

http://www.senecawoodworking.com/products/domiplate-for-1-2-and-3-4-ply

This is a great product for getting joints to line up flush repeatedly.  There is a side specifically sized for 3/4 plywood, and one for 1/2 plywood. 

In this example, however, I was really trying to make a mid-panel joint.  It was close enough to the end of the board that I was concerned someone might have missed the small inset I was trying to achieve.