I got so tired of the guide stops for my OF1400 banging around loose in the OF's systainer, and I had no where to put my LR-32 plate and OF-FH routing guide or a decent way of storing and transporting of often used cutters to the job. I had to do something. Oh... I also made a 5mm snap in base so I could toss that stupid support foot which that and its knob always seem to get in the way when laying the router on its side to change cutters.
It all fits into a Sys-3. The bottom is a piece of 1/2 baltic birch notched so the LR32 plate can fit. The bit holders are from Lee Valley. I'm not sure but I think they have them for 8mm shanks as well.
It all fits into a Sys-3. The bottom is a piece of 1/2 baltic birch notched so the LR32 plate can fit. The bit holders are from Lee Valley. I'm not sure but I think they have them for 8mm shanks as well.